FS: 2V HP Blower Cams

ok, i bought these from Mug11 and am told by some they wont work for my application, even though Mug11 and Houston Performance says they will. Rather than take a chance and spend the money to find out if they will work or not, im just going to go a different route.

Here is the info...

They are Custom Grinds
Houston Performance
.531/.531 Lift
292/292
.050 Duration
114* Lobe Seperation

they are in GREAT condition, with ZERO score marks or anything of the such.

Just looking to get back what i paid, but if your interested Post up some offers. I will entertain all.

I will provide pictures only to those seriously interested. I need to sell these asap so i can order my new ones and get them here.

Please send me a guestbook message or an email to frogiiie@adelphia.net if your interested as i always forget to check the forums on this site..

those cam stats can't be right... are you sure that duration is at .050???

thats the advertised specs...they were actually 228 @ .50 duration.....in any event, they have since been sold.

quick sale on a good set of cams...pretty low mileage, i remember pullin those babies out

car made good numbers

these are long gone after mug11 took advantage of me by lying and telling me these were billet cams when they were regrinds. he is a piece of shit and i hope it comes back around.

how much are you selling them for and are they already sold

see above post, cams are gone.
again...these are blower cams. they would be no good for a n/a car....
you would need other supporting mods to have cams similar to these, such as valve spring upgrades and rear end gear upgrades.
start out with the basics and work your way up.

Quote:

---

Originally Posted by GirlzGT

these are long gone after mug11 took advantage of me by lying and telling me these were billet cams when they were regrinds. he is a piece of shit and i hope it comes back around.

---

u stated yourself that u weren't sure if they were or not...he was told they were by someone, u were told the same...mug is not in the wrong here

first...dont defend his ignorance. you dont know the entire story, nor the thread where they were listed, nor have you read the PMs...i have.
i asked if they were billet and he told me YES. there are obvious HUGE differences between billet cams and reground stock cams. You should know what your having put in your car.
second....because he was given wrong info is not my fault. when i brought it to his attention by me, he should have had me send them back for a refund, not tell me to deal with it and just sell them if i dont like them.
this is ultimately what happened because he ignored my messages. and guess what, that little difference between billet and regrinds cost me a ton of money, because i was not able to sell them for what i paid.
bottom line is, mug is a piece of lying garbage who doesnt stand behind his sales. he refused to communicate with me at all. telling me to stop sending him messages. it was bullshit and he knows it. i have every PM to prove it.
i believe in karma, and believe it will come back to bite him...i just wish i could see it.

J, can you close this thread, this crap has been over with for a while now.