PDA

View Full Version : Gauges HELP


iluvmystang
01-01-2005, 01:05 PM
Ok. I have a E.L Gauge Kit. (electro-luminescense)

I don't know if I just put these over my factory ones, or if they are a new whole thing or what.

These are the directions, and they don't make since to me, so see if you can figure them out and help me.

1. Make sure about the model of car on your application when purchasing shine Dash-Panel kit.

2. Remove the Dash-Panel kit and take off the face cover.

3. Loosen the bolts and let needles through the hole of Dash-Panel then screw back the bolts.

4. The needles of Dash-Panel can be painted by a marker pen, You may choose your color.

5. Find out the light's anode and cathode by multitaster from back of dashboard and connect them.

So I don't know really how to do this, can someone help me please!?
95mustang302
01-01-2005, 02:41 PM
damn those are a pain in the ass trust me i tried it once!
iluvmystang
01-01-2005, 02:49 PM
Well did you get it to work?

What did you do?
Joe Friday
01-01-2005, 03:29 PM
all you ahve to do is remove the bezzle from the dash, once you get it out remove the plastic clear housin gby removing the 8 bolts. next you just slide the needles through the holes of the new gauge kit and they should fit right over the stock gaudges. :D
iluvmystang
01-01-2005, 03:29 PM
Mine has all kinds of wiring and crap.

Does that mean I have to take the old gauges off and put the new ones back on there?

If so I think I'm gona sell them and get some that just go over the stock ones?
AcidKoolz
01-01-2005, 07:53 PM
pix of the wiring?
mysteed
01-09-2005, 02:17 PM
I told you that I would help you. Geez! Don't you trust me?
Joe Friday
01-09-2005, 06:20 PM
Mine has all kinds of wiring and crap.

Does that mean I have to take the old gauges off and put the new ones back on there?

If so I think I'm gona sell them and get some that just go over the stock ones?


there is no way you can not get this.. run the wiring out of the gaudge pod and put it back togeather.. now install the power inverter. hook the positive to your dash light fuse, and the negative to a good ground source. There is a screw under the carpet that holds up the center of the consoul that is perfect. hook the wires from the power box to the wires you left out of the gaudge pod. turn on your lights to make sure they work... reinstall everything.