ADVICE FOR MY NEW 347 STROKER, CAM HELP

[car9fan]

Iam looking for some advice for my new 347 Stroker its got 10.5.1 Comp. Iam useing my Edelbrock RPM heads, with roller rockers and .202-.160 valves 60cc,And a Stealth Intake, 700 DF,DP Holley All MSD Ignition, Its a 1985 Block. It has a 3000 Stall, Full C4 Race Trans, 410 Gears. The car weighs 3000 lbs. I would like to go with a soild lift cam, Thanks for Any advice on the lift and Dur. @ 50.

[90gt]

Ed at flowtechinduction.com knows his stuff I have one of his custom grinds I would not get no where near the power out of my combo with any other cam!!!!!!!

[91GT347]

The Comp XE274HR,works very well also.

[car9fan]

THANKS FOR THE INFO BUT IAM LOOKING FOR A SOILD LIFT CAM, DO YOU THINK A 245@50 DUR. AND 560 LIFT WOULD BE OK AS FAR AS PISTON TO VALVE CLEARANCE? THANKS CAR9FAN

[5.0literriceeater]

There is no thinking with piston to valve clearance. Just check it. Better to be safe than sorry!

[91GT347]

That depends on the pistons that you have. I would call whoever you got the stroker from and ask. Even if they say it will work,5.0liter is right. You should always check. Especially with a cam that big.

[car9fan]

Thanks for the advice, its a roller cam, The motor is running great STRONG, I made 2 eazy passes on it, Only shifting at 5000 RPMs And a 12.03 and then 11.86 at 116 mph Iam going to shift the car at 6800 when it gets good and broke in, Thanks CAR9FAN

[91GT347]

Nice !! Made a good full pass yet ?